Section 4: General Configuration; Transmitter Displayed Messages; 1: The Read-Only Sequence - Honeywell XYR 5000 series User Manual

Honeywell Process Solutions

Section 4: General Configuration

4.1: Transmitter Displayed
Messages
NOTE
During configuration and testing, keep Transmit-
ters at least six feet from the Base Radio and other
Transmitters.

4.1.1: The Read-Only Sequence

Rev. 8
July 2012
Wireless Dual Analog Input Interface Transmitter
This section discusses general configuration of the Transmitter via the
NEXT and ENTER buttons. The subsections are as follows:

4.1: Transmitter Displayed Messages

4.1.1: The Read-Only Sequence
4.2: The Overall Configuration Menu Map
4.3: Setting a Transmitter Tag Name
4.4: Setting a User Password
4.5: Resetting All Transmitter Settings
To turn the Transmitter on, press and hold both the NEXT and ENTER
buttons for a few seconds. Upon power up, the Transmitter will display
the Power-Up Sequence, and then go into the Operations Sequence. These
sequences are shown in Figure 4.1.
Figure 4.1: Transmitter Power-UP and Operations LCD Sequences
Once the Transmitter is in the Operations Sequence, a user may access the
Read-Only Sequence without a password by simply pressing the ENTER
button at any time. The Read-Only Sequence, as shown in Figure 4.2, dis-
plays extra information about the current settings of the Transmitter that is
not seen during the Operations Sequence, but does not allow any changes
to be made to these settings.
4.2: The Read-Only Sequence
User Manual 15