How To Assemble Your Monitor Hardware - BenQ MD SERIES User Manual

How to assemble your monitor hardware

• If the computer is turned on you must turn it off before continuing.
Do not plug-in or turn-on the power to the monitor until instructed to do so.
• The following illustrations are for your reference only. The location and available input and output jacks may
vary depending on the purchased model.
This monitor has the integrated front sensor. Do not touch the integrated front sensor or apply any stress to it
while carrying the monitor.
1. Rotate the monitor.
Gently lift the monitor, turn it over and place it upright
on its stand on a flat even surface.
Extend the monitor to the maximum extended position.
Then tilt the monitor. And rotate the monitor 90
degrees clockwise as illustrated.
You should position the monitor and angle the screen to
minimize the unwanted reflections from other light sources.
2. Adjust the monitor height.
To adjust the monitor height, hold both the left and the
right sides of the monitor to lower the monitor or lift it
up to the desired height.
16 How to assemble your monitor hardware
90