Turning In Manual Mode - Siemens SINUMERIK 840DE Operation & Programming Manual

4
Turning Simple Contours

4.1 Turning in manual mode

4.1

Turning in manual mode

Example of facing
Example of taper turning
Straight
4-64
Function
Conventional feed traversal for facing, longitudinal and taper turning
operations that have no specific end point is performed in MANUAL
mode.
After a tool number, spindle speed and feedrate have been entered,
the direction of motion is preset, for example, with a control stick.
The direction indicator on the operator interface always indicates the
direction of travel.
For taper machining operations, it is possible to preselect a 45° angle
with the control stick and to define additional angles using the
"Conical" function.
100
Ø
Z+
X+
Z+
X+
In addition, in MANUAL mode you can traverse the axes to a certain
position and execute simple machining sequences or start the
program from a specific position.
Sequence of operations
Select MANUAL mode.
a) Facing/longitudinal turning
Select the soft key labeled "Straight".
4 °
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition
4
08.02