Siemens SINUMERIK 840DE Operation & Programming Manual page 179

11
08.02
Reaction
Remedy
111 301
Explanation
Reaction
Remedy
111 302
Explanation
Reaction
Remedy
111 303
Explanation
Reaction
Remedy
111 304
Explanation
Reaction
Remedy
111 305
Note
Reaction
Remedy
111 306
111 307
111 308
111 309
111 310
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition
Alarm display
NC start disable
Replace key
NC stop key defective
Checkback signal to PLC user program that NC stop key is defective,
i.e. N.C. and N.O. signal = 1
Alarm display
NC start disable
Replace key
Spindle start key defective
Checkback signal to PLC user program that spindle start key is
defective, i.e. N.C. and N.O. signal = 1
Alarm display
NC start disable
Replace key
Spindle stop key defective
Checkback signal to PLC user program that spindle stop key is
defective, i.e. N.C. and N.O. signal = 1
Alarm display
NC start disable
Replace key
Connection to PLC broken
Checkback signal to PLC user program that connection to
MANUALTURN is broken.
Alarm display
MANUALTURN-PLC terminated
Check PLC user program.
Asynchronous subroutine not processed
In the asynchronous subroutine, internal settings in the NC are
triggered by the user interface. If any of the alarms 111 306 to
111 310 is triggered, these settings cannot be executed.
Alarm display
Press NC reset.
Error on selection or deselection of constant cutting speed
Error on resetting handwheel offset
Error on setting spindle speed upper limit
Error on selecting tool
Error on selecting zero offset
Alarms and Messages
11.2 Alarms with ManualTurn
11
11-179