Zero Offset - Siemens SINUMERIK 840DE Operation & Programming Manual

3
08.02

3.4.5 Zero offset

Reselect zero offset
Offset
ZO 1 ZO 4
...
Deselect zero offset
ZO 1 ZO 4
...
Input zero offset
Offset
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition
Sequence of operations
Select any operating mode
Press the soft key labeled "Offset" in the extended soft key bar
and select a new zero offset with the relevant soft key
"> <" marks the zero offset you have activated
Press the soft key for the selected zero offset again.
The zero offset is deselected.
Select the soft key labeled "Offset" in the extended soft key menu in
any mode.
Use the cursor keys to select a zero offset, e.g. ZO1
Enter value for "X" (e.g. 100) and "Z" (e.g. 200).
Confirm your settings with "Input".
Enter other data if required.
You can enter data if no start command has been given.
Preparatory Functions for Machining
3.4 Offsets
3
3-51