Simultaneous Recording; Dry Run - Siemens SINUMERIK 840DE Operation & Programming Manual

9
08.02

9.1.2 Simultaneous recording

Simultan-
eous rec.
Delete
screen

9.1.3 Dry run

Dry run

Dry run
feedrate
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition
9.1 Simulation and simultaneous recording
Function
The results of an EasyStep machining sequence can be displayed on
the screen in real time by means of the "Simultaneous recording"
function.
Sequence of operations
You can select the "Simultaneous recording" function in the extended
soft key menu of every operating mode.
Press the "Spindle start" and "NC start" keys to start execution.
The same soft key functions are available as under "Simulation" (see
Section "Simulation"). The function "Delete screen" is also available.
Select this soft key to delete the current screen contents.
Function
You can simulate a programmed EasyStep machining sequence on
the screen by activating the "Dry run" function.
Explanation of soft keys
All axis movements on the machine tool are disabled.
The "Dry run" soft key only appears if no program is active, that is, if
the program is in RESET state (press RESET key).
When you press the soft key "Dry run feedrate", the feed movements
are simulated at the dry run speed specified in the machine data.
Additional notes
In a dry run the machine and auxiliary functions are output by the NC
and can be suppressed by the machine manufacturer, if required.
Please follow the advice of the machine manufacturer.
9
General Functions
9-159