Connecting To Host Via Ethernet - Omron NS12-TS00 Setup Manual

5-1 Connecting to Host Via Ethernet

5-1 Connecting to Host Via Ethernet

To connect to the network using Ethernet, the network number, node number, and IP address
must be set. Use the NS-Designer to set the settings. For details, refer to Section 7 System
Settings of the NS-Designer Operation Manual and Section 9 Ethernet Connection of the Tu-
torial included in the NS-Designer CD-ROM.
The following connection methods are possible when connecting via the Ethernet only.
· Connecting PT Directly to the Host
Connect the PT to the host using twisted-pair cross cable.
PT
· Connecting PT to Host with a Hub
Multiple PTs and hosts can be connected using twisted-pair straight cable and a hub.
Twisted-pair
straight cable
10Base-T
PT 1
· Connecting PT and Host Using Transceivers
PTs can be connected in a 10Base-5 network configuration by using a hub and transceiver
that support 10Base-5.
Terminator
· Devices Required for Network Configuration
The following additional devices are required to configure the network using the Ethernet and
must be purchased separately.
Always use products that conform to IEEE802.3 standards for all network configuration de-
vices.
5-2
Twisted-pair cross cable
10Base-T
Hub
PT 2
Host 1
Transceiver
Coaxial cable
Transceiver
10Base-5
cable
Hub
Twisted-pair
straight cable
10Base-T
PT 2
PT 1
Host
Host 2
Transceiver
Terminator
Host 2