Siemens Simatic ET 200SP Manual page 25

Address space
The following figure shows the assignment of the address space for the AQ 2xU/I HS with
value status (Quality Information (QI)). The addresses for the value status are only available
if the value status is enabled.
Figure 4-2
Address space of the AQ 2xU/I HS for oversampling with one channel
The following figure shows the assignment of the address space for oversampling with one
channel. Writing always starts from QB x. Only a maximum of 16 sub-cycles are possible.
Figure 4-3
Analog output module AQ 2xU/I HS (6ES7135-6HB00-0DA1)
Manual, 09/2016, A5E03576140-AD
Address space of the AQ 2xU/I HS with value status
Address space of the AQ 2xU/I HS for oversampling with one channel
Parameters/address space
4.5 Address space
25