Table of Contents
Advertisement
5
Logical Ethernet Interfaces and VLANs
Introduction
Logical Ethernet interfaces can be configured to support following VLAN features:
VLAN tagging
of traffic at the WAN-side
Support of
VLAN routing
VLAN tagging parameter
A logical Ethernet interface can be assigned to a VLAN using the
command.
If the parameter is set to the
default, the interface is assigned to the default VLAN.
If the parameter is set to
tagged with the specified VLAN.
=>:eth ifconfig intf=eth_video vlan=video
=>:eth iflist intf=eth_video
eth_video
: Dest: eth_total
E-DOC-CTC-20080229-0001 v1.0
5|
Logical Ethernet Interfaces and VLANs
on the Thomson Gateway
default
VLAN, the logical Ethernet interface transmits untagged frames. By
another
VLAN, the frames transmitted by the logical Ethernet interface are
Connection State: not-connected
WAN: Enabled
Priority Tagging: Disabled
PortNr: (unassigned)
VLAN: video
vlan
parameter of the
Retry: 10
:eth ifconfig
33
Advertisement
Table of Contents
