Eth Bridge Dynvlan Delete - THOMSON R7.4 Configuration Manual

4| Ethernet Bridge and VLANs
Listing dynVLAN membership information
To list the entries of the
=>:eth bridge dynvlan list
ID
--
50
When a device with a MAC address from the table is connected to the bridge, an entry is added to the list of
active entries. To display information on the
command:
=>:eth bridge dynvlan actlist
Index ID
50 0
Deleting dynVLAN membership entries
To remove a specific entry

:eth bridge dynvlan delete

Following parameter must be specified:
Id: this parameter identifies the entry to be deleted.
=>:eth bridge dynvlan list
ID
--
50
=>:eth bridge dynvlan delete id=50
=>:eth bridge dynvlan list
ID
--
Before you delete an entry, list all entries to obtain the correct identifier of the entry to be deleted.
To remove all entries
=>:eth bridge dynvlan list
ID
--
50
=>:eth bridge dynvlan flush
=>:eth bridge dynvlan list
ID
--
Applications
The Flexiport mechanism is based on the dynVLAN membership mechanism. If the Flexiport mechanism is
used in combination with dynamic MAC addresses, even more than four devices can make use of Flexiport.
24
dynVLAN membership table, execute following command:
MAC Address
-----------
00:19:b9:2d:0f:c1
active MAC entries
MAC Address VLAN
00:19:b9:2d:0f:c1 data
from the dynVLAN membership table, execute the command
.
MAC Address
-----------
00:19:b9:2d:0f:c1
MAC Address
-----------
from the dynVLAN membership table, execute following command:
MAC Address
-----------
00:19:b9:2d:0f:c1
MAC Address
-----------
VLAN RemVLAN (* = dynamic)
---------- ----------
data (none)
and their timeout, execute following
Interface
ethport3
VLAN RemVLAN (* = dynamic)
---------- ----------
data (none)
VLAN RemVLAN (* = dynamic)
---------- ----------
VLAN RemVLAN (* = dynamic)
---------- ----------
data (none)
VLAN RemVLAN (* = dynamic)
---------- ----------
Timeout
92
E-DOC-CTC-20080229-0001 v1.0