3 - 18
PROPELLER SHAFT
DOUBLE CARDAN UNIVERSAL JOINTS (Continued)
(5) Flip propeller shaft yoke and install other bear-
ing cap onto the opposite trunnion and install a snap
ring (Fig. 46).
Fig. 46 PRESS IN BEARING CAP
(6) Fit link yoke onto remaining trunnions and
press both bearing caps into place and install snap
rings (Fig. 47).
Fig. 47 INSTALL LINK YOKE
(7) Install centering kit assembly inside the link
yoke (Fig. 48).
NOTE: Verify spring is properly positioned.
Fig. 48 INSTALL CENTERING KIT
(8) Place two bearing caps on opposite trunnions of
the remaining cross. Fit open trunnions into the link
yoke bores and bearing caps into the centering kit
(Fig. 49).
Fig. 49 INSTALL REMAINING CROSS
DR