Advertisement
Bodywork
7 . 5
6 . 4 ~ All cables, hoses and wiring pass
through the centre of the cover
6.6a On Speedfight 2 models, undo the
three screws (arrowed)
. . .
6.6b
. . .
and lift off the front panel
Front panel (liquid-cooled models)
13 Installation is the reverse of removal.
Ensure the headlight unit and grille are
properly located in the panel and the fixings
are tightened securely. Ensure the U-clips are
in place (see illustration 6.12b). Ensure the
tabs on the sides and lower edge of the panel
are correctly located before tightening the
fixing screws. Connect the headlight wiring
connector and check the operation of the
headlight.
6 On the Speedfight 1, the front panel is
retained by one screw on the top edge of the
panel. On the Speedfight 2, the panel is
retained by three screws (see illustration).
Undo the screw(s) and lift off the panel (see
illustration).
7 Installation is the reverse of removal.
Headlight panel
Note: Although visually similar, the arrange-
ment of the front body panels differs between
the liquid and air-cooled models to allow access
to the coolant reservoir and radiator. Air-cooled
Speedfight 1 variants have a one-piece front/
headlight panel with no grille or separate front
panel. The front body panels were redesigned
for the Speedfight 2 models. If required, the
headlight panel can be removed with the front
panel attached to it. On air-cooled Speedfight 2
variants, the grille was blanked off.
8 Undo the four screws in the kick panel (see
illustration).
9 Undo the two screws on the lower front
edge of the panel (see illustration).
10 Pull the panel forward to disengage the
fixing tabs from the kick panel and the front
side panels, and disconnect the headlight
wiring connector (see illustrations).
11 The headlight unit is retained in the panel
by four screws; undo the screws and remove
the unit (see illustration).
12 The grille is retained by two of the
headlight unit screws and a third screw in the
centre top of the grille (see illustration).
Remove the screws and unclip the tabs on the
grille to remove it (see illustration).
6.8 Headlight panel is retained by four
screws in the kick panel
. . .
6.9
. . .
and two screws on the front lower
edge
6.10a Pull the panel forward to disengage
the tabs (arrowed)
. . .
6.10b
. .
.
and disconnect the wiring
connector
6.11 Four screws retain the headlight unit
6.12b
.
. .
and tabs at either side (A). Note
the U-clip on the panel fixing (B)
6.12a Grille is retained by central screw..
.
Advertisement
