Configuring An Additional Metric For A Rip Interface - HP 830 Series Configuration Manual

11.1.1.0/24
12.3.1.0/24
12.3.1.2/32
16.4.1.0/24
16.4.1.1/32
127.0.0.0/8
127.0.0.1/32

Configuring an additional metric for a RIP interface

Network requirements
As shown in
Switch E.
Switch A has two links to Switch D. The link from Switch B to Switch D is more stable than that from Switch
C to Switch D. Configure an additional metric for RIP routes received through VLAN-interface 200 on
Switch A so Switch A prefers route 1.1.5.0/24 learned from Switch B.
Figure 57 Network diagram
Vlan-int100
1.1.1.1/24
Switch A
Vlan-int200
1.1.2.1/24
Configuration procedure
1. Configure IP addresses for interfaces. (Details not shown.)
2. Configure basic RIP:
# Configure Switch A.
<SwitchA> system-view
[SwitchA] rip 1
[SwitchA-rip-1] network 1.0.0.0
[SwitchA-rip-1] version 2
[SwitchA-rip-1] undo summary
[SwitchA-rip-1] quit
# Configure Switch B.
<SwitchB> system-view
[SwitchB] rip 1
[SwitchB-rip-1] network 1.0.0.0
[SwitchB-rip-1] version 2
[SwitchB-rip-1] undo summary
# Configure Switch C.
<SwitchC> system-view
[SwitchB] rip 1
RIP
Direct 0
Direct 0
Direct 0
Direct 0
Direct 0
Direct 0
Figure 57, run RIPv2 on all the interfaces of Switch A, Switch B, Switch C, Switch D, and
Vlan-int100
1.1.1.2/24
Switch B
Vlan-int200
1.1.2.2/24
Switch C
100 1 12.3.1.1
0 12.3.1.2
0 127.0.0.1
0 16.4.1.1
0 127.0.0.1
0 127.0.0.1
0 127.0.0.1
Vlan-int400
1.1.3.1/24
Vlan-int400
1.1.3.2/24
Vlan-int300
Vlan-int500
1.1.4.2/24
1.1.5.1/24
Switch D
Vlan-int300
1.1.4.1/24
147
Vlan200
Vlan200
InLoop0
Vlan400
InLoop0
InLoop0
InLoop0
Vlan-int500
1.1.5.2/24
Switch E