Configuration Procedure; Configuring Ripng Route Control; Configuring An Additional Routing Metric - HP 830 Series Configuration Manual

Configuration procedure

To configure the basic RIPng functions:
Step
1. Enter system view.
2. Create a RIPng process and
enter RIPng view.
3. Return to system view.
4. Enter interface view.
5. Enable RIPng on the interface.
NOTE:
If RIPng is not enabled on an interface, the interface does not send or receive any RIPng route.

Configuring RIPng route control

Before you configure RIPng, complete the following tasks:
Configure an IPv6 address on each interface, and make sure all nodes are reachable to one
•
another.
Configure RIPng basic functions.
•
• Define an IPv6 ACL before using it for route filtering. For related information, see ACL and QoS
Configuration Guide.

Configuring an additional routing metric

An additional routing metric can be added to the metric of an inbound or outbound RIP route.
The outbound additional metric is added to the metric of a sent route. The route's metric in the routing
table is not changed.
The inbound additional metric is added to the metric of a received route before the route is added into
the routing table, and the route's metric is changed.
To configure an inbound or outbound additional routing metric:
Step
1. Enter system view.
2. Enter interface view.
3. Specify an inbound routing
additional metric.
4. Specify an outbound
routing additional metric.
Command
system-view
ripng [ process-id ]
quit
interface interface-type
interface-number
ripng process-id enable
Command
system-view
interface interface-type interface-number
ripng metricin value
ripng metricout value
153
Remarks
N/A
Not created by default.
N/A
N/A
Disabled by default.
Remarks
N/A
N/A
Optional.
0 by default.
Optional.
1 by default.