Ipv6 Basics Configuration Example; Network Requirements; Configuration Procedure - HP 830 Series Configuration Manual

Task
Display ND snooping
entries.
Clear FIB cache entries.
Clear IPv6 neighbor
information.
Clear the path MTU values.
Clear the statistics of IPv6
and ICMPv6 packets.
Clear all IPv6 TCP
connection statistics.
Clear the statistics of all IPv6
UDP packets.
Clear ND snooping entries.

IPv6 basics configuration example

Network requirements

As shown in
Ethernet ports into corresponding VLANs, configure IPv6 addresses for the VLAN interfaces and verify
that they are connected.
Enable IPv6 on the host to obtain an IPv6 address automatically through IPv6 ND.
The VLAN interfaces have been created on the switch.
Figure 52 Network diagram

Configuration procedure

1. Configure Switch A:
# Enable IPv6.
<SwitchA> system-view
[SwitchA] ipv6
# Specify a global unicast address for VLAN-interface 2.
[SwitchA] interface vlan-interface 2
[SwitchA-Vlan-interface2] ipv6 address 3001::1/64
[SwitchA-Vlan-interface2] quit
Command
display ipv6 nd snooping [ ipv6-address | vlan
vlan-id ] [ | { begin | exclude | include }
regular-expression ]
reset ipv6 fibcache { slot-number | all }
reset ipv6 neighbors { all | dynamic | interface
interface-type interface-number | slot slot-number |
static }
reset ipv6 pathmtu { all | static | dynamic}
reset ipv6 statistics [ slot slot-number ]
reset tcp ipv6 statistics
reset udp ipv6 statistics
reset ipv6 nd snooping [ ipv6-address | vlan vlan-id ]
Figure 52, a host, Switch A and Switch B are connected through Ethernet ports. Add the
115
Remarks
Available in any view.
Available in user view.
Available in user view.
Available in user view.
Available in user view.
Available in user view.
Available in user view.
Available in user view.