Ipv6 Static Routing Configuration Example - HP 830 Series Configuration Manual

IPv6 static routing configuration example

Network requirements
As shown in
Figure 54 Network diagram
Configuration procedure
1. Configure the IPv6 addresses for all VLAN interfaces. (Details not shown.)
2. Configure IPv6 static routes:
# Enable IPv6 and configure an IPv6 static route on Switch A.
<SwitchA> system-view
[SwitchA] ipv6
[SwitchA] ipv6 route-static :: 0 4::2
# Enable IPv6 and configure two IPv6 static routes on Switch B.
<SwitchB> system-view
[SwitchB] ipv6
[SwitchB] ipv6 route-static 1:: 64 4::1
[SwitchB] ipv6 route-static 3:: 64 5::1
# Enable IPv6 and configure an IPv6 static route on Switch C.
<SwitchC> system-view
[SwitchC] ipv6
[SwitchC] ipv6 route-static :: 0 5::2
3. Configure the IPv6 addresses for all the hosts based on the network diagram, and configure the
default gateway of Host A as 1::1, Host B as 2::1, and Host C as 3::1.
4. Verify the configuration:
# Display the IPv6 routing table of Switch A.
[SwitchA] display ipv6 routing-table
Routing Table : Public
Destination: ::
NextHop
Figure 54, configure IPv6 static routes so that hosts can reach one another.
Destinations : 5
: 4::2
Routes : 5
129
Protocol : Static
Preference: 60