Cisco Aironet 1570 Series Installation Manual page 55

Chapter 3 Mounting the Access Point
Assemble the cable clamps to the cable bracket, on both cable brackets (see
Step 1
hand-tighten the nuts sufficiently enough to only prevent them from falling off.
Figure 3-5
5
1
3
5
Secure each cable bracket with two M8 x16 bolts (with lock washers) on the back surface of the access
Step 2
point.
When installing external antennas, which are mounted on the AP using an additional antenna bracket,
Tip
the AP may tilt to one side due to the uneven weight distribution. To counteract this tilt, elongated M8x16
bolt holes are provided on the cable bracket. This allows you to adjust the cable brackets' position
against the AP's back surface, to cancel the tilt.
OL-32138-01
Assembling Cable Clamps on Cable Bracket
1
5/16"-18 bolt
5/16"-18 nut
Cable Bracket
(Figure 3-7). Hand-tighten the bolts to 13 to 15 lb.ft (17.6 to 20.3 Nm).
Cisco Aironet 1570 Series Outdoor Access Point Hardware Installation Guide
2
3
4
2 Cable Clamps
4 M8 x16mm bolt
Strand Mount Kit 2
Figure 3-5). You should
3-11