Verifying Controller Association - Cisco Aironet 1570 Series Installation Manual

Verifying Controller Association

Table 5-1 Access Point LED Signals (continued)
1, 2, 3
LED Color
RF-1 Black
Steady green
Steady red
RF-2 Black
Steady green
Steady red
1. If all LEDs off, the access point has no power.
2. When the access point power supply is initially turned on, all LEDs are amber.
If the power supplied in insufficient, then all LEDs blinking amber at 1 second intervals. Supply sufficient power to remedy this.
3. If the temperature of the AP exceeds its working temperature range, then the AP shuts down, with all LEDs blinking amber at 0.5 sec intervals. The
Wireless LAN Controller is also notified. The AP reboots automatically when the temperature gets back within the working range.

Verifying Controller Association

To verify that your access point is associated to the controller, follow these steps:
Step 1 Log into your controller web interface using a web browser.
You can also use the controller CLI show ap summary command from the controller console port.
Click Wireless, and verify that your access point MAC address is listed under Ethernet MAC.
Step 2
Log out of the controller, and close your web browser.
Step 3
Cisco Aironet 1570 Series Outdoor Access Point Hardware Installation Guide
5-6
Meaning
Radio turned off or LED off.
Radio is operational; network is good.
Firmware failure. Contact your support organization for assistance.
Radio is turned off or LED off.
Radio is operational; network is good.
Firmware failure. Contact your support organization for assistance.
Chapter 5 Troubleshooting
OL-32138-01