Vapor Hose And Fuel Filler Cap; Vacuum Crankcase Ventilation Hoses; Valve Clearance (Gasoline - Gamma 1.4L/1.6L); Cooling System Checks - Hyundai Accent 2013 Owner's Manual

Operation maintenance specifications
Hide thumbs Also See for Accent 2013:
Table of Contents

Advertisement

Maintenance

Vapor hose and fuel filler cap

The vapor hose and fuel filler cap should
be inspected at those intervals specified
in the maintenance schedule. Make sure
that a new vapor hose or fuel filler cap is
correctly replaced.
Vacuum crankcase ventilation
hoses (if equipped)
Inspect the surface of hoses for evidence
of heat and/or mechanical damage. Hard
and brittle rubber, cracking, tears, cuts,
abrasions, and excessive swelling indi-
cate deterioration. Particular attention
should be paid to examine those hose
surfaces nearest to high heat sources,
such as the exhaust manifold.
Inspect the hose routing to assure that
the hoses do not come in contact with
any heat source, sharp edges or moving
component which might cause heat dam-
age or mechanical wear. Inspect all hose
connections, such as clamps and cou-
plings, to make sure they are secure, and
that no leaks are present. Hoses should
be replaced immediately if there is any
evidence of deterioration or damage.
7
32
Air cleaner filter
A Genuine HYUNDAI air cleaner filter is
recommended
when
the
replaced.
Spark plugs (for gasoline engine)
Make sure to install new spark plugs of
the correct heat range.
Valve clearance
(Gasoline - Gamma 1.4L/1.6L)
Inspect excessive valve noise and/or
engine vibration and adjust if necessary.
An authorized HYUNDAI dealer should
perform the operation.
Cooling system
Check cooling system components, such
as radiator, coolant reservoir, hoses and
connections for leakage and damage.
Replace any damaged parts.
Coolant
The coolant should be changed at the
filter
is
intervals specified in the maintenance
schedule.
Manual transaxle fluid
(if equipped)
Inspect the manual transaxle fluid
according to the maintenance schedule.
Automatic transaxle fluid
(if equipped)
The fluid level should be in the "HOT"
range of the dipstick, after the engine
and transaxle are at normal operating
temperature.
transaxle fluid level with the engine run-
ning and the transaxle in neutral, with the
parking brake properly applied.
Check
the
automatic

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents