Windshield Wipers; Windshield Washers - Hyundai Accent 2013 Owner's Manual

Operation maintenance specifications
Hide thumbs Also See for Accent 2013:
Table of Contents

Advertisement

Features of your vehicle

Windshield wipers

Operates as follows when the ignition switch is turned ON.
MIST (
) : For a single wiping cycle, push the lever upward
and release it with the lever in the OFF position.
The wipers will operate continuously if the lever is
pushed upward and held.
OFF (O) : Wiper is not in operation
INT (---)* : Wiper operates intermittently at the same wiping
intervals. Use this mode in a light rain or mist. To vary
the speed setting, turn the speed control knob.
LO (1) : Normal wiper speed
HI (2) : Fast wiper speed
*: if equipped
✽ NOTICE
If there is heavy accumulation of snow or ice on the wind-
shield, defrost the windshield for about 10 minutes, or until the
snow and/or ice is removed before using the windshield wipers
to ensure proper operation.
If you do not remove the snow and/or ice before using the
wiper and washer, it may damage the wiper and washer sys-
tem.
4
82
■ Type A
■ Type B
ORBC040056E/ORB040056E/OTA040056/ORB041408

Windshield washers

In the OFF (O) position, pull the lever gently toward you to spray
washer fluid on the windshield and to run the wipers 1-3 cycles.
Use this function when the windshield is dirty.
The spray and wiper operation will continue until you release
the lever.
If the washer does not work, check the washer fluid level. If the
fluid level is not sufficient, you will need to add appropriate non-
abrasive windshield washer fluid to the washer reservoir.
The reservoir filler neck is located in the front of the engine
compartment on the passenger side.
■ Type C
■ Type D

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents