Paxar Monarch 9414 Equipment Manual page 38

Problem
Printing stops and
indicator light turns
ORANGE.
The printer does
not detect the gap
between each
label.
The
keypad/terminal
displays an error.
A-2 Troubleshooting
Action
Adjust the label gap sensor.
Turn off the printer.
1.
Load labels for non-peel mode.
2.
See Chapter 2, "Using the Pizza
Hut Application."
Press and hold the FEED button
3.
while turning the printer on.
Release the FEED button when
4.
the indicator light starts flashing
red. Several labels advance
including the status label.
Press the FEED button.
5.
Problem with the supply. Load
different supply. See Chapter 2,
"Using the Pizza Hut Application."
Clear a label jam. See "Clearing
Label Jams," in Chapter 3.
Software problem. Check the printer
memory configuration. See your
System Administrator.
Adjust the label gap sensor.
Turn off the printer.
1.
Load labels for non-peel mode.
2.
See Chapter 2, "Using the Pizza
Hut Application."
Press and hold the FEED button
3.
while turning on the printer.
Release the FEED button when
4.
the printer starts advancing
lines. Several labels advance
including two Diagnostic labels.
Press the FEED button.
5.
Clear the error, turn off the printer
and then back on.