Tearing Supply - Paxar 9430R Operator's Handbook Manual

3. Drop the supply into the well. Make sure the supply
unwinds from the bottom as shown.
4. Position the supply between the printhead guides.
5. Make sure 2-3 inches of supply extends past the
printhead.
6. Close the supply door.
7. Turn on the printer.
T e a r i n g S u p p l y
The printer's supply door acts as a tear bar. Tear down
against the tear bar to remove receipts.
NOTE: Do not tear supply up against the printhead or
sideways, because the supply door may open.
Tear Bar
2-2 Loading Supplies