Loading The Multipurpose Feeder - Lexmark XS795dte Quick Reference

Notes:
•
Place pre-punched paper with the holes toward the front
of the tray.
•
Place letterheads faceup with the header on the left side
of the tray.
•
Place letterheads facedown with the header on the right
side of the tray for duplex printing.
5
Insert the tray.

Loading the multipurpose feeder

The multipurpose feeder can hold several sizes and types of print
media, such as transparencies, labels, card stock, and envelopes.
It can be used for single-page or manual printing, or as an
additional tray.
The multipurpose feeder can hold approximately:
•
2
100 sheets of 75‑g/m (20‑lb) paper
•
10 envelopes
•
75 transparencies
The multipurpose feeder accepts paper or specialty media within
the following dimensions:
•
Width—89 mm (3.5 in.) to 229 mm (9.02 in.)
•
Length—127 mm (5 in.) to 1270 mm (50 in.)
Note: Maximum width and length can be applied only to short-
edge feeding.
Note: Do not add or remove paper or specialty media when the
printer is printing from the multipurpose feeder or when the
printer control panel indicator light is blinking. Doing so may
cause a jam.
1
Pull down the multipurpose feeder door.
2
For paper or specialty media that is longer than letter-size
paper, gently pull the extension until it is fully extended.
3
Flex the sheets of paper or specialty media back and forth to
loosen them. Do not fold or crease them. Straighten the edges
on a level surface.
Loading paper and specialty media
8
Paper
Envelopes
Transparencies
Note: Avoid scratching or touching the print side.