Fluke MultiFiber Pro User Manual page 35

A
The relative level of power or power loss measured on
the channel. For loss measurements, the limit line and
OK or show. See Figure 7 on page 16 and Figure 10
on page 24 for descriptions of these measurements.
B
The channel for the measurement shown (
change the channel, press
C
POLARITY: The polarity used for the connections
between the meter and source.
D
To change the channel for the measurement shown
F
( ), press or
E
Use DELETE to delete records. See "Delete Records"
on page 27.
F
The measurement for the selected channel. To see the
measurement for the next channel, press
.
If the 12 records for a cable have been deleted,
shows for each channel.
G
The fiber number.
H
The record number for the measurement shown.
I
The wavelength for the measurement. AUTO
the source was in auto wavelength mode during the
measurement.
F
). To
D
or ( ).
.
or
shows if
To use LinkWare software to delete all the records in
memory
1 Install the latest version of LinkWare software on your
PC.
2 Turn on the meter.
3 Connect the meter to the PC with the USB cable
provided, as shown in Figure 12.
4 Start LinkWare software on the PC.
5 On the LinkWare toolbar, select Utilities > MultiFiber
Pro > Delete All Tests in Memory.
Memory Functions
29