Table of Contents
Advertisement
T
T
T
GranDSLAM 4200 Turn-up Procedure
You can turn up your GranDSLAM 4200 through the Ethernet connection via a PC
or terminal connected to the unit's CONSOLE port. Then, using a series of TL1
commands or an NMS system such as Paradyne's GrandVIEW Element
Management System (EMS), you configure the unit for operation.
The turn-up procedure for the GranDSLAM 4200 system differs, depending on the
type of management used:
T
T
The turn-up procedure for both management types also differs, depending on
whether you are in Manual mode (no DHCP server), or in DHCP (BOOTP) mode
using a DHCP server.
T
T
4200-A2-GN20-10
Command query. You can obtain help with CLI commands by typing a ?
(question mark). A question mark alone lists all commands.
For example, if you enter:
RTRV ?
the CLI lists all the possible RTRV commands.
Command history. Pressing the Up Arrow key while entering a command
returns the CLI to the previous command entry.
RTRV-META command. Retrieves all commands.
Inband Management – Operates over the ATM interface. This is the default for
the GranDSLAM 4200.
Out-of-Band Management – Operates over the Ethernet interface.
Manual Mode – If a DHCP server is not being used, you must manually assign
an IP address to your GranDSLAM 4200.
DHCP Mode – If you are using a DHCP server, you do not need manually
assign an IP address since this is done automatically.
October 2002
4. Configuration
4-3
Advertisement
Table of Contents
