Cot Assembly - Step - John Lewis Martha Sleigh cotbed Instruction Manual

Cot assembly - step 2

Part D
Push two barrel nuts (Fixing 1) into the holes in the underside edges of the base (Part D) so that the
slot in the end is visible and is in line with the base rail. If it is not, use a flat-bladed screwdriver to
correct it.
Select the desired base position from the three available.
NOTE: the lowest position is the safest and should always be used as soon as your child is able to sit up
unaided.
Attach the base (Part D) to the assembly from step 1 using four 65mm bolts (Fixing 3).
Do not fully tighten the bolts at this stage.
Cot assembly - step 3
Part B
Attach the second Side panel (Part B) using two 45mm bolts (Fixing 2). Do not fully tighten bolts.
Push two Dowels (Fixing 4) into the holes in the lower leg of the End panel (Part A) and then attach
the Drawer trim (Part C) by pushing it onto the Dowels. Ensure that the curve in this part is on the
lower edge.
Fixing 1
Fixing 2
Part C
2 x Fixing 3
3 Optional
positions
2 x Fixing 4
4