Mackie DC16 Owner's Manual page 73

Hide channel names in selected channel editing:
By default, when a SELECTED channel editing mode is selected, the channel's names and
numbers are presented in the channel display along with the editing mode characteristics.
However, if you would prefer the channel names and numbers not be there – only displaying
the editing mode characteristics – simply change this setting to "On".
Rotate the encoder until you see the choice you prefer between:
On
Off [Default]
See below for the same exact example of this feature, one with OFF selected and one with
ON selected. Notice the difference between the two. The choice really comes down to if you
want input and output names and channels displayed or not. Displayed certainly makes
it easier to see what bank you're on (and what channels are on them), but hiding them may
make it easier to focus on the editing parameters. Regardless of your choice, inputs and
outputs may be selected as always with the selected channel display showing your selection.
OH Kick
1
ON
Off
EQ
EQ
OH
ON
On
EQ
EQ
Calibrate Faders:
This is simply the place to calibrate the faders. Press the encoder to begin fader calibration.
The channel display will present "In progress... " during fader calibration and "Do it!" when
finished. When wrapped up, the faders will return to the position they were in prior to
calibration. The entire process should only take approximately 10 seconds.
About:
This is the place to view the settings of this particular DC16. Press the encoder to display similar
settings as seen below. Press the "Cancel" encoder when you are finished with this view.
Connected Connected
Mixer Type Mixer Name
DL32R DC16
S Top S Btm
2 3
Hz
MODERN 45
EQ TYPE HPF FREQ
Hz
MODERN 45
EQ TYPE HPF FREQ
This feature should only be used if the faders aren't moving or aren't accurately
representing their positional value. Make sure that the faders are not obstructed
during calibration and do not touch them during calibration.
Connected IP Mode
Slot Name
FOH Dynamic
HiHat Tom Rack
4 5 6
dB Hz
9.0 50
BAND 1 GAIN BAND 1 FREQ
dB Hz
9.0 50
BAND 1 GAIN BAND 1 FREQ
IP Address System
Version
10.0.1.10 18.062
73
DC16 Owner's Manual
OH Ch 9
7 8 9
dB
1.4 7.0
BAND 1 Q BAND 2 GAIN
dB
1.4 7.0
BAND 1 Q BAND 2 GAIN
Firmware
Version
18.068
Ch 10
10
Hz
250
BAND 2 FREQ
Hz
250
BAND 2 FREQ
Cancel