Manual Pairing Between The Amplifier And Subwoofer - Sharp HT-SB60 Service Manual

HT-SB60
4.
As for subwoofer Abnormal Detection, there are 3 types of detection.
The detection is by simple RED LED flashing indicating Abnormal Status.
No Abnormal Detect
(1) Repeated Bus Error
(2)
System Protect
(3)
AMP Shutdown

[3] Manual pairing between the Amplifier and Subwoofer.

After changing the TX or RX Wireless Modules, the Sound bar and Subwoofer must establish a link. Set the connection by the
following method.
1
Press and hold the PAIRING button on the sound bar for more than 3 seconds.
2
Within 2 minutes, press and hold the PAIRING button on the subwoofer for more than 3 seconds.
During pairing process:
On sound bar :
On subwoofer :
When pairing is successful:
On sound bar :
On subwoofer :
Sound Bar
Red LED blinking for 2 times and pause cycle.
Red LED blinking for 4 times and pause cycle.
Red LED blinking for 5 times and pause cycle.
"PAIRING" will blink.
indicator will blink in blue.
"PAIRING" disappears.
indicator turns blue.
Process
Subwoofer
PAIRING
2 – 3