Program Edit Mode
KB3 Editor: The PITCH Page
Volume
Use the Volume parameter to set the preset volume of each of the nine drawbars. The
available values will be
0–8 or 0–127, depending on the setting of the Steps parameter.
Tune
This parameter lets you tune each of the nine drawbars up or down in semitone steps. The
values for the Tune parameter on the DRAWBR page shown above represent standard
drawbar settings on a real B3, as shown in the table below.
Subharmonics
16'
Slider A
KB3 Editor: The PITCH Page
The PITCH page parameters for KB3 programs are much like the Pitch parameters for VAST
programs on the DSPMOD page. The only difference is that for KB3 programs, there are
no Hz, KeyTrk, or VelTrk parameters. For a full description of the PITCH-page parameters,
see
Common DSP Control
Modulation (DSPMOD) Page.
7-88
Fundamental
5
/3'
8'
1
Slider B
Slider C
Figure 7-2 Standard Drawbar Settings for the Hammond B3
Parameters,
Harmonics
4'
2
/3'
2'
2
Slider D
Slider E
Slider F
The DSP Control (DSPCTL) Page
1
/5'
1
/3'
1'
3
1
Slider G
Slider H
Slider I
and
The DSP