Advertisement
60
57
56
FIGURE 18
STEP 18
• Insert the PUSH/PULL CABLE through the bottom of the PRESS ARM (27) up to the CONTROL LEVER (60) and hold in place
with one E-RING (56) as shown in FIGURE 18.
• SECURELY assemble the PUSH/PULL CABLE to the CONTROL LEVER (60) using one 3/8" JOINT CONNECTOR CAP (57),
one #8 INT. TOOTH LOCK WASHER (59), and one 8-32 X 3/16 IN. SCREW (58) as shown in FIGURE 18.
• Slide one 4" VINYL SLEEVE (47) over the CONTROL LEVER (60). Then SECURELY assemble the CONTROL LEVER (60) to
the TAB on the PRESS ARM (27) using one 3/8" JOINT CONNECTOR CAP (57), one #8 INT. TOOTH LOCK WASHER (59),
and one 8-32 X 3/16 IN. SCREW (58) as shown in FIGURE 18.
1/2
0
27
58
59
1/2
1
2
47
PUSH/PULL
CABLE
1/2
1/2
3
17
1/2
4
5
1/2
6
Advertisement
