Advertisement
FIGURE 17
STEP 17
• Insert two 1/2" FLANGE BEARINGS (78) into the LEG CURL/EXT (15) as shown on FIGURE 17.
• Assemble the LEG CURL/EXT (15) to the FRONT UPRIGHT (25) using one 1/2 X 3" BOLT (87) and one 1/2" LOW HEIGHT
NUT (95). (NOTE: Tighten the connection enough to remove play, yet allowing the LEG CURL/EXT to rotate freely.)
• Assemble two ROLLER PADS (37) to the ROLLER PAD ADJUST (11) using two STARLOCK COLLARS (50).
• SECURELY assemble one 3/8" SPRING PIN (51) to the ROLLER PAD ADJUST (11) as shown in FIGURE 17.
• Slide ROLLER PAD ADJUST (11) over the LEG CURL/EXT (15) until the spring pin pops into the holes. See FIGURE 17.
• SECURELY assemble one 3/8 X 1" BUTTON HEAD CAP SCREW (96) and one 3/8" LOCK NUT (92) to the last hole in the
LEG CURL/EXT (15) as shown in FIGURE 17.
•
Insert one 2" SQ. END CAP (46) into the end of the LEG CURL/EXT (15) as shown in FIGURE 17.
25
87 1/2 X 3"
50
78
92
11
37
16
95 LOW HEIGHT NUT
78
15
96 3/8 X 1"
BUTTON
HEAD
51
46
Advertisement
