Rinnai RHFE-557FT Manual page 27

AIR INLET HOSE
Maxfold
Inlet hose
Plastic tie
-0CKING CLAMP SCREW CLAMP AND
NSULATION.
The following components can be fitted by
reaching down the rear of the appliance as it is
positioned against the wall.
1. Connect the flue outlet to the manifold by
extending the stainless steel sliding tube until it
is fully inserted into the manifold.
Manifold
Sliding Tube
III
51 I
f
Slide
Do not extend flue tube
beyond red line.
2. Fit the locking clamp over connection
between sliding tube and manifold. Engage the
hook and rotate it until it snaps against the
body of the clamp.
Manifold
P
Locking
clamp
Looking
Clamp
3. Fit the screw clamp between the sliding tube
and the flue elbow. Secure with the 4 mm screw
supplied. The flue outlet is now locked into
position.
saew
Locking damp
Flue elbow
4. Slide the insulation sleeve up to the flue
manifold, slip the securing clip over the sleeve
as shown.
Fit clip
slide insulation sock
n
I I
/
I
Sliding tube -
Flue elbow I
sodc
slide to herf
-27-