Rinnai RHFE-557FT Manual page 24

o not install the heater in an unusually dusty
rea.
FOR WEATHERBOARD WALLS DRILL
THROUGH CENTREOFWEATHER BOARD
FROM OUTSIDE, THEN DRILL FROM INSIDE
THROUGH PLASTERBOARD.
I
se a flue guard if the terminal is easily
ccessible to children.
heck local regulations.
uards are available as an optional extra.
Guard
'loor must be level.
IO not use electrical extension cords to connect
mit to power supply.
Ceep the power cord away from the flue.
:LUE MANIFOLD POSITION.
:entre of hole for flue manifold can be drilled
anywhere within the shaded area. (To avoid
tuds etc.)
I
Flue Hole
I I
I
Before drilling the flue hole, check for water and
gas pipes as well as electric cables.
Use an 80 mm (8 cm) drill for hole through wall.
WALL MOUNTING BRACKETS
Place top back spacer in position. Mark the position
of the top edge of the top spacer on the wall. Move
the heater away from the wall. Mark centre lines
30 mm down from the top edge mark, and 40 mm in
front the left and right hand sides of the top spacer.
Attach wall brackets at the marked position.
Remove right hand back cover.
-24-