Interface - Panasonic AJ-SD965 Operating Instructions Manual

Setup menus
(continued)
USER menu
<INTERFACE>
No./Item
200 This selects whether two or more VTRs are
to be operated in synchronization.
PARA RUN
0000
0001 ENA : Operation in synchronization
<Note>
When operating two or more VTRs in
synchronization, set all the VTRs to ENA.
201 This selects whether the 9P connector is to
function when the REMOTE button is set to
9P SEL the remote mode (REMOTE lamp ON).
0000
0001
202 This sets the ID information to be returned to
the controller.
ID SEL
0000 OTHER
0001 DVCPRO
0002 ORIG
<Notes>
OID information of any VTR except for the
DVCPRO's is set in OTHER.
OThe ORIG setting should only be used when a
Panasonic controller (AG-A850 etc. sold
separately) is connected.
203 This selects whether the PARALLEL (25P)
connector is to function when the REMOTE
25P SEL button is set to the remote mode (REMOTE
lamp ON).
0000
0001
204 This selects whether the RS-232C connector
is to function when the REMOTE button is
RS232C SEL set to the remote mode (REMOTE lamp ON).
0000
0001
205 These settings are for selecting the RS-232C
communication speed (baud rate).
BAUD RATE
0000
0001
0002 1200
0003 2400
0004 4800
0005 9600
206 These settings are for selecting the RS-232C
data length. (Unit: bit)
DATA LENGTH
0000
0001
207 These settings are for selecting the RS-232C
stop bit length. (Unit: bit)
STOP BIT
0000
0001
The underlined items indicates the initial setting.
Description
DIS : No operation in synchronization
OFF : Connector does not function.
ON : Connector functions.
OFF : Connector does not function.
ON : Connector functions.
OFF : Connector does not function.
ON : Connector functions.
300
600
7
8
1
2
No./Item
208 These settings are for selecting the none,
odd or even for the RS-232C parity bit.
PARITY
0000 NON :
Parity bit is not used.
0001 ODD:
An odd number of bits is used for the parity
system.
0002 EVEN:
An even number of bits is used for the parity
system.
209 These settings are for selecting whether the
ACK code is to be returned when a command
RETURN ACK is received from RS-232C.
0000 OFF : ACK code is not returned.
0001
210 For selecting the method used to detect the
STANDBY COMMAND signal input at the
25P STBY CMD PARALLEL (25P) connector.
0000 OFF/ON :
Each time active signals are detected, the
STANDBY ON or STANDBY OFF mode is
selected alternately.
0001
When active signals are detected in the
STANDBY OFF mode, the unit is transferred
to the STANDBY ON mode.
Nothing happens if they are detected during
an operation in the STANDBY ON mode.
211 This selects whether the PARALLEL (25P)
connector is to function when the REMOTE
LOCAL 25P button is set to the local mode (REMOTE
lamp OFF).
0000 OFF : Connector does not function.
0001
212 For selecting the remote control connector to
control the slave when the unit is used as the
MASTER PORT master during deck-to-deck operations.
0000 IN/OUT : The IN/OUT connector is used.
0001 OUT : The OUT connector is used.
<Note>
This setting takes effect only when the REMOTE
button is set to the local mode (REMOTE lamp
OFF).
Description
ON : ACK code is returned.
ON :
ON : Connector functions.
45