Braking system
See also
Front brake calliper
Refitting
To fit, proceed as follows:
- Insert the two pads in the callipers.
- Screw the two pad lock pins to the correct torque,
and apply the recommended product.
- Fit the calliper on its support, tightening the two
screws to the prescribed torque.
N.B.
IF IT IS NOT POSSIBLE TO CORRECTLY PO-
SITION THE CALLIPER ON THE DISC DURING
FITTING, GENTLY EXPAND THE PADS.
Recommended products
Loctite 243 Medium strength threadlock
Loctite 243 medium-strength threadlock
Locking torques (N*m)
Screw tightening calliper to the support 24 ÷
27 Pad fastening pin 19.6 ÷ 24.5
Rear brake pads
BRAK SYS - 8
Downloaded from
www.Manualslib.com
manuals search engine
X7 250ie