Setting Procedures - Panasonic WV-CF254 Operating Instructions Manual

SETTING PROCEDURES

1. Camera Identification (CAMERA ID)
Setting
You can use the camera identification (CAMERA
ID) to assign a name to the camera. The camera ID
consists of up to 16 alphanumeric characters. You
can select whether to have the camera ID dis-
played on the monitor screen or not.
** CAM SET UP **
CAMERA ID
ALC/ELC
SHUTTER
AGC
SYNC
WHITE BAL
END SET UP ENABLE
To edit the CAMERA ID
1. Move the cursor to the CAMERA ID parameter.
2. Press (S). The CAMERA ID menu appears.
The cursor on the letter "0" starts blinking.
Character Cursor
0123456789
ABCDEFGHIJKLM
NOPQRSTUVWXYZ
().,'":;&#!?=
+-*/%$
SPACE
POSI RET END RESET
................
Pointer
CAMERA ID menu
3. Move the cursor to the character you want to
change by pressing
(D).
4. After selecting the character, press
The selected character appears in the editing
area. (The pointer in the editing area moves to
the right automatically at this moment.)
5. Repeat the steps above until all characters are
edited.
To enter a blank space in the CAMERA ID
Move the cursor to SPACE and press
To edit a specific character in the CAMERA ID
1. Move the cursor to the editing area by press-
ing (S).
2. Move the pointer to the character to be edited
by pressing (L) or
cursor to the character area and select a new
character.
3. Press (S) to determine the CAMERA ID.
OFF
ALC
---
ON
INT
ATW
Character
Area
Command
Editing
Area
(L)/ (R)/ (U)/
(S).
(S).
(R). Then move the
To erase all characters in the editing area
Move the cursor to RESET and press
characters in the editing area disappear.
To determine the display position of the
CAMERA ID
1. Move the cursor to POSI, and press
The display shown below appears and the
CAMERA ID starts blinking.
2. Move the CAMERA ID to the desired position
by pressing
3. Press (S) to fix the position of the CAMERA
ID. The mode returns to the previous CAMERA
ID menu.
Notes:
• The CAMERA ID stops at the edges of the
monitor screen.
• The CAMERA ID moves faster if any of
(L)/
pressed for a second or longer.
To return to the CAM SETUP menu
Move the cursor to RET and press
CAM SETUP menu appears.
2. Light Control Setting (ALC/ELC)
You can select one of the following light control
modes:
ALC: This camera has an ALC lens..
ELC: If you select this mode, the iris is kept open.
Select a SHUTTER parameter to control the
brightness.
** CAM SET UP **
CAMERA ID
ALC/ELC
SHUTTER
AGC
SYNC
WHITE BAL
END
1. Move the cursor to the ALC/ELC parameter.
2. Select ALC or ELC.
-15-
Blinking
WV-CF254
(L)/ (R)/ (U)/
(R)/ (U)/ (D) is kept
(S). The
OFF
ALC
---
ON
INT
ATW
SET UP ENABLE
(S). All
(S).
(D).