HP MSR4080 Configuration Manual page 85

[RouterC-ospf-1-area-0.0.0.0] network 168.1.1.0 0.0.0.255
[RouterC-ospf-1-area-0.0.0.0] quit
[RouterC-ospf-1] quit
# Configure a QoS policy.
[RouterC] traffic classifier qppb
[RouterC-classifier-qppb] if-match qos-local-id 1023
[RouterC-classifier-qppb] quit
[RouterC] traffic behavior qppb
[RouterC-behavior-qppb] car cir 2000 green pass red discard
[RouterC-behavior-qppb] quit
[RouterC] qos policy qppb
[RouterC-qospolicy-qppb] classifier qppb behavior qppb
[RouterC-qospolicy-qppb] quit
# Enable MPLS on interface GigabitEthernet 2/1/1.
[RouterC] interface gigabitethernet 2/1/1
[RouterC-GigabitEthernet2/1/1] mpls enable
[RouterC-GigabitEthernet2/1/1] mpls ldp enable
# Enable QPPB on interfaces GigabitEthernet 2/1/0 and GigabitEthernet 2/1/1.
[RouterC-GigabitEthernet2/1/1] bgp-policy
[RouterC-GigabitEthernet2/1/1] quit
[RouterC] interface gigabitethe
[RouterC-GigabitEthernet2/1/0] bgp-policy destination ip-qos-map
[RouterC-GigabitEthernet2/1/0] qu
# Bind interface GigabitEthernet 2/1/0 to the VPN instance vpn1.
[RouterC] interface gigabitethernet 2/1/0
[RouterC-GigabitEthernet2/1/0] ip binding vpn-instance vpn1
[RouterC-GigabitEthernet2/1/0] ip address 169.1.1.2 24
# Apply the QoS policy qppb to the incoming and outgoing traffic of interfac
2/1/0.
[RouterC-GigabitEthernet2/1/0] qos apply policy qppb inbound
[RouterC-GigabitEthernet2/1/0] qos apply policy qppb outbound
5. Configure a BGP connection on Router D.
<RouterD> system-view
[RouterD] bgp 300
[RouterD-bgp] peer 169.1.1.2 as-number 200
[RouterD-bgp] peer 169.1.1.2 connect-interface gigabitethernet
[RouterD-bgp] address-family ipv4
[RouterD-bgp-ipv4] peer 169.1.1.2 enable
[RouterD-bgp-ipv4] import-route direct
[RouterD-bgp-ipv4] quit
Verifying the configuration
# Verify that the related routes on Router A take effect.
[RouterA] display ip routing-table
Destinations : 18
rnet 2/1/0
it
Routes : 18
83
destination ip-qos-map
e GigabitEthernet
2/1/1