Konica Minolta bizhub PRO C1060L Quick Manual page 69

R
Press [Close] to exit the adjustment.
Scan Measurement Adjustment is then
completed.
- To register adjustment values in a paper
profile, press [Register].
-
For details about how to register a paper
profile, refer to the HTML User's Guide.
)Gap Adjustment
To adjust a gap, print out a chart, measure a gap between the front and back sides at the specified measurement point
of the back side using a scale to determine the adjustment value, and enter it. (Adjust the zoom ratio and image
position of the back side based on the image position of the front side.)
Using this function, you can only enter adjustment values to adjust a gap. This is convenient in order to adjust an
unclear misalignment detected on the back side that occurs when performing duplex printing with a new type of paper
or when paper in a tray has been changed.
NOTICE
The Gap Adjustment is a simple method to adjust only the zoom ratio and image position of the back side. To also
adjust it on the front side, carry out "Chart Adjustment" (page 5-15) or "Zoom and Image Shift Adjustment"
(page 5-22).
A
Press [Paper Setting] on the [MACHINE]
screen.
B
Select the tray with the target paper
loaded, then press [Change Set].
bizhub PRESS C1070/C1070P/C1060/C71hc
bizhub PRO C1060L
5
5-10