Table of Contents
Advertisement
For the ultimate in convenience, install two
refrigerators side to side.
This trim kit includes 6 foam spacer pads to fill
the gap between the refrigerator side case
trims. For a finished appearance, a trim strip is
provided to conceal the side case trim of the
two refrigerators.
If you are installing into an enclosure, provide
a 72" wide opening. If you are installing where
the sides of the refrigerators will be exposed,
allow additional width for any side panels used.
• Apply foam spacer pads evenly to the side of
one refrigerator as shown.
• Slide second refrigerator into position.
• Check to be sure both refrigerators are level.
If they are not level, an obvious gap can be
seen between the side trims. Adjust leveling
legs if needed. Slight gaps will be concealed
with the trim strip.
• Open both fresh food doors to access side
trim.
• The U-shape trim will overlap the side case
trim of both refrigerators.
• Set the top case trim (see page 12) to installa-
tion height.
• Hold U-shaped trim strip up against case trim
as shown. Mark length with pencil at the
point where U-shaped trim overhangs case
trim at bottom.
• Mark length with a pencil.
• Trim excess length.
• Starting at the top, press U-shaped trim strip
over case trims of both refrigerators.
• Continue pressing about half way down. Slide
open freezer drawers and continue pressing
trim until you reach the bottom of the strip.
ZFC1 Trim Kit
Side to Side Installation
Case Trim
Foam
Spacer
Pads
U-Shape
Trim
14
Advertisement
Table of Contents
