Table of Contents
Advertisement
Answering System Features
l
Changing the number of rings
You can change the number of times the
phone rings before the unit answers calls.
You can select 2 to 7 rings, or "Auto".
"Auto": The unit answers after 2 rings when
new messages have been recorded, and
after 5 rings when there are no new
messages. If you call your phone from
outside to listen to new messages (page
54), you will know that there are no new
messages when the phone rings for the 3rd
time. You can then hang up without being
charged for the call.
1
" (centre of joystick) i l i #
2
"Settings" i #
3
"Number of Rings" i #
4
Select the desired setting. i # i
{ih}
For voice mail service subscribers
Please note the following:
– To receive messages correctly with your
voice mail service, we recommend that
you do not use the unit's answering
system. Make sure that the answering
system is turned off (page 51).
– If you would rather use the unit's
answering system rather than the voice
mail service provided by your service
provider, ask your service provider to
deactivate your voice mail service.
If your service provider cannot do this, set
this unit's "Number of Rings" setting
so that this unit's answering system
answers calls before the service
provider's voice mail service tries to
answer your calls. It is necessary to check
the number of rings required to activate
the voice mail service provided by your
service provider before changing this
setting.
56
Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
Selecting the caller's recording
time
You can change the maximum message
recording time allotted to each caller, or set
the unit to greet callers but not record
messages.
1
" (centre of joystick) i l i #
2
"Settings" i #
3
"Recording Time" i #
4
Select the desired setting. i # i
{ih}
Turning call screening on
While a caller is leaving a message, you can
screen the call through the handset speaker.
1
" (centre of joystick) i l i #
2
"Settings" i #
3
"Call Screening" i #
4
"On" i # i {ih}
Turning message alert on
This feature alerts you when new messages
have been recorded. The base unit beeps
about once a minute until you have listened
to all new messages.
1
" (centre of joystick) i l i #
2
"Settings" i #
3
"New Msg. Alert" i #
4
"On" i # i {ih}
Note:
L If the base unit is in night mode, the base
unit will not beep when new messages are
recorded.
Advertisement
Table of Contents
