Frequently Asked Questions; Check And Fault Messages In The Display - Miele PT 7186 Vario Operating And Installation Instructions

Frequently asked questions

With the help of the following notes minor faults in the performance of the
appliance, some of which may result from incorrect operation, can be put right
without contacting the Service Department.
,
Repairs to electrical appliances must only be carried out by a qualified and
trained technician in accordance with local and national safety regulations.
Unauthorized repairs could cause injury or machine damage.

Check and fault messages in the display

Problem
1
Adjust the load
The drum is empty or
the laundry is too dry.
;
Technical fault
If restart is unsuccessful,
call Service.
A fault number
(e.g. F43) might also
be displayed.
:
Power failure
Program stopped
Press OK button
30
Possible cause
This is not a fault.
In some programs, if the
drum has been
overloaded or
underloaded, the
program will be
canceled. This can also
happen if the items are
already dry.
A program cannot be
started while there is a
fault message in the
display.
The dryer was switched
off during a drying
program or there has
been a power cut:
Remedy
Use the Hot air program
(timed drying) to dry
individual items.
To delete the message:
– Open the door.
– Make a note of what
is shown in the
display.
– Try to start the
program again.
– When the machine is
switched on again
and/or the power is
restored, confirm with
OK and start the
program again.