Step
6
• Install the water inlet extension fitting and
Install
• The 90° elbow should face the left side of
Water Inlet
Fittings
7
• To protect the countertop from moisture,
Step
Protect the
Countertop
8
• Remove the screw holding the junction box
Step
• Install a strain relief onto the junction box.
• Tighten the strain relief against the incom-
Connect
Electrical
• Strip 1/2" insulation from end of wires.
(For Power Cord
• Connect incoming wires to dishwasher wires
Installation Only)
• Push all wires into the junction box and
IMPORTANT: Power cord must be no longer
than 6 feet from the junction box to the plug.
Do not plug in power cord at this time.
90° elbow (not supplied) onto the dish-
washer. Use thread sealing tape or pipe
thread compound.
the dishwasher.
apply the self-adhesive plastic strip provided
to the underside of the countertop.
to the dishwasher frame. Remove the
junction box.
ing wires.
using wire nuts of appropriate size. Connect
white to white, black to black and incoming
ground to green wire.
place on dishwasher frame. Secure with
screw.
Note: The power
cord and connection
must comply with the
National Electrical
Code, Section 422
and/or local codes
and ordinances.
Installation
Stainless Steel Interior Dishwashers
Note: 90° elbow
should face the left
side.
Screw
17