Table of Contents
Advertisement
3
Use the template supplied to find the location
of the support brackets which hold the custom
A
Step
panel to the front of the dishwasher door.
• Check to be sure the spacer bar below the
(continued)
• Measure the total height of the control
Secure
• Find and mark that location on the graded
Custom
Panel to
Dishwasher
• Lay the custom panel on a flat surface with
• Place the template on the panel with the
• Tape the template in place and use an awl to
• Remove the template and drill pilot holes
• Secure all brackets to the custom panel using
control panel is set to the desired location.
panel. See illustration on page 12.
rule on both top corners of the template.
the appearance side down. Locate the
vertical center of the panel at the top. Use a
carpenters square to draw a center line from
top to bottom on the panel.
large "V" notch at the top and small "V"
notch at bottom. Align the template center
line to the center line drawn on the panel.
Align the top of the template with dimen-
sions previously marked on the graded rules.
The windows on both sides of the template
will help you align the template to the panel
accurately.
mark screw hole locations indicated.
3/32" deep in the marked locations.
Screws (B) provided.
3/4" Custom Panels
Models ZBD4800X Dishwashers
MM
115
125
135
145
155
Screw B
INCHES CONTROL PANEL HEIGHT
4-3/4
5
5-1/4
5-1/2
14
Advertisement
Table of Contents
