Step 2 Remove Wood Base, Install Leveling Legs; Step 3 Remove Toekick; Step 4 Install Power Cord; Step 5 Install 90° Elbow - GE ZBD6800K Installation Instructions Manual

STEP 2
REMOVE WOOD BASE,
INSTALL LEVELING LEGS
IMPORTANT
Damage will occur.
• Move the dishwasher close to the installation location
and lay it on its back.
• Remove the four leveling legs on the underside of
the wood base with an adjustable wrench or 15/16"
socket.
• Discard base.
Figure H
• Screw leveling legs back into the dishwasher frame,
approximately 1/4" from frame as shown.
STEP 3 REMOVE TOEKICK
• Remove the two toekick screws.
Figure J
Installation Instructions
Do not kick off wood base!
—
Approx.
1/4"
Remove 2
Toekick Screws
STEP 4
INSTALL POWER CORD
Skip this step if dishwasher will be direct wired or
has a factory installed power cord.
The power cord and connections must comply with
the National Electrical Code, Section 422 and/or local
codes and ordinances.
• Maximum power cord length is 4 feet beyond the
back of the dishwasher.
A
Insert Power
Remove
Cord Wires Thru
Junction Box
Strain Relief
Cover
and Tighten
C Check That White, Black and
Green Dishwasher Wires Are Threaded
Thru Small Hole in Bracket
Figure K
• Connect incoming power cord white (or ribbed) to
dishwasher white, black (or smooth) to black and
ground to dishwasher green wire. Use UL listed wire
nuts of appropriate size.
• Replace junction box cover. Be sure wires are not
pinched under the cover.
STEP 5 INSTALL 90° ELBOW
• Wrap 90° elbow with thread seal tape.
• Install a 90° elbow onto the water valve.
90°
Elbow
Figure L
• Do not overtighten 90° elbow, water valve bracket
could bend or water valve fitting could break.
• Position the end of the elbow to face the rear of the
dishwasher.
8
B
White
Ground
D
Use UL Listed
Wire Nuts
Front of Dishwasher
Water Valve
Bracket
Fill
Hose
Thread
Seal Tape
Black