Control Features; Throughout This Manual, Features And Appearance May Vary From Your Model; About The Dishwasher Control Panel - GE GLDT690J__BB Technical Service Manual

Throughout this manual, features and appearance may vary from your model.

About the dishwasher control panel

Start Dishwasher
Start/Reset: Press the Start/Reset button and close the door within 4 seconds to start
the cycle or begin the Delay Start countdown. The Start/Reset LED will light. The wash
dishwasher with water. To activate the display, press any button with the door open.
Interrupt or Pause: To interrupt or pause a cycle, slowly open the door. Opening the
door will cause the wash cycle to pause. The dishwasher will beep every minute as a
reminder to close the door. To restart or resume the cycle, press Start/Reset, and close
the door within 4 seconds. If the door is not closed within 4 seconds, the Start/Reset
LED will start blinking and the dishwasher will beep once every minute to signal that the
cycle did not restart. If the Start/Reset LED is blinking, the dishwasher is waiting for input.
Cancel: To cancel a wash cycle, press and hold the Start/Reset button for 3 seconds with
the door open, and then close the door. The dishwasher will drain and the wash cycle
lights will turn off.
Wash Cycle Selections
Press the Select button to choose a wash cycle. The light above the cycle name will
display to indicate which cycle has been selected.
Delay Start Option
This option allows a delay the start of a wash cycle for up to 24 hours.
With the door open, turn the dishwasher ON by pressing the ON/OFF button; then press
the DELAY button to choose the number of hours wanted to delay the start of the wash
cycle. The hours will show in the display window.
NOTE: Press the Start/Reset button to cancel the Delay hours option before the start of the
cycle.
2 Digit Display
This display is used for DELAY START and cycle time countdown.
When a cycle is selected, the display is populated with the total number of minutes in
the cycle, until it reaches 99 minutes (Sanitize, Heavy and Normal cycles).
Status Indicators
SANITIZED: If the SANITIZE cycle is selected, the sanitized indicator light will be turned on
at the end of the cycle. If the NSF requirements for sanitization are not reached, the light
will not turn on.
CLEAN: The green light will display and a beep will sound to alert that the wash cycle is
complete. If the door is NOT opened, the beep will sound 4 times.

Control Features

– 7 –
(Continued next page)