Two-Riser Chassis - Dell SD630-S Owner's Manual

Two-riser chassis

Figure 3. Back panel features (two PCIe expansion cards)
1. System identification button
3. iDRAC8 Enterprise port
5. Serial connector
7. USB ports (2)
9. Ethernet connectors (4)
11. Power supply unit (PSU2)
Table 3. Back panel features (two PCIe expansion cards)
Item Indicator, Button, or
Connector
1 System identification
button
2 System identification
connector
3 iDRAC8 Enterprise port
2. System identification connector
4. PCIe expansion card slot (riser 1)
6. Video connector
8. PCIe expansion card slot (riser 2)
10. Power supply unit (PSU1)
Icon Description
The identification buttons on the front and back
panels can be used to locate a particular system
within a rack. When one of these buttons is
pressed, the LCD panel on the front and the
system status indicator on the back flash until one
of the buttons is pressed again.
Press to toggle the system ID on and off. If the
system stops responding during POST, press and
hold the system ID button for more than five
seconds to enter BIOS progress mode.
To reset iDRAC (if not disabled in F2 iDRAC setup),
press and hold for more than 15 seconds.
Enables you to connect the optional system status
indicator assembly through the optional cable
management arm.
Dedicated management port.
NOTE: The port is available for use only if the
iDRAC8 Enterprise license is installed on your
system.
13