Table of Contents
Advertisement
Removing the network daughter card
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1.
Follow the safety guidelines listed in the Safety instructions section.
2.
Follow the procedure listed in the Before working inside your system section.
3.
Keep the Philips #2 screwdriver handy.
Steps
1.
Remove the expansion card riser 3.
2.
Using a Phillips #2 screwdriver, loosen the two captive screws that secure the Network Daughter
Card (NDC) to the system board.
3.
Hold the NDC by the edges on either side of the touch points and lift to remove it from the
connector on the system board.
4.
Slide the NDC away from the back of the system until the Ethernet connectors are clear of the slot in
the back panel.
5.
Lift the NDC out of the system.
107
Advertisement
Table of Contents
Troubleshooting
