Serial Ports - Siemens RUGGEDCOM RS910 Installation Manual

RUGGEDCOM RS910
Installation Guide
1
Figure 11: MTRJ Port
1. Tx Connector 2. Rx Connector
1
Figure 13: SC Port
1. Tx Connector 2. Rx Connector
For specifications on the available fiber optic Ethernet ports, refer to
Specifications".
Section 3.3

Serial Ports

The RS910 supports DB9, RJ45 and SC (Standard or Subscriber Connector) fiber serial ports, all of which can be
run in RS232, RS485 or RS422 mode.
NOTE
On power-up, all serial ports default to RS485 mode. Each port can be individually set to RS232,
RS485 or RS422 mode through ROS. For more information, refer to the ROS User Guide for the
RS910.
All serial ports feature an LED that indicates the current state of the port.
State
Green
Off
For specifications on serial ports, refer to
For information about how to connect devices configured to run in RS485 mode, refer to
Multiple RS485 Devices".
The following are the pin-outs for the DB9, RJ45 and SC connectors:
Serial Ports
2
Figure 12: LC Port
1. Tx Connector
2
Figure 14: ST Port
1. Tx Connector
Description
Link activity detected
No link detected
Section 4.6, "Serial Port
1
2. Rx Connector
1
2. Rx Connector
Section 4.5, "Fiber Optic Ethernet Port
Specifications".
Section 3.4, "Connecting
Chapter 3
Communication Ports
2
2
15