Suunto ZOOP User Manual page 54

the screwdriver onto the side of the right tooth on the ring (Fig. 5.2) and turn the
ring clockwise. Care should be taken not to damage any of the parts.
4. Remove the ring.
5. Carefully remove the lid with the beeper attached to it. The lid can be removed
by pressing with your finger on the outermost edge of the lid while at the same
time pulling with your nail at the opposite side. Do not use sharp metal objects
as they might damage the O-ring or the sealing surfaces.
6. Remove the O-ring and the battery retainer.
7. Carefully remove the battery. Do not damage the electrical contacts or the
sealing surface.
Check for any traces of flooding, particularly between the beeper and the lid,
or for any other damage. In case of a leak or any other damage, bring the dive
computer to an authorized SUUNTO dealer or distributor for check and repair.
8. Check the condition of the O-ring; a defective O-ring may indicate sealing or
other problems. Dispose the old O-ring, even if it seems to be in good condition.
9. Check that the battery compartment, battery holder and lid are clean. Clean
with soft cloth if necessary.
10. Gently insert the new battery in the battery compartment. Check the polarity
of the battery: the "-" mark should point toward the bottom of the compartment
and the "+" mark upwards.
11. Reinstall the battery retainer in its correct position.
12. Check that the new lubricated O-ring is in good condition. Put it in the right
position on the battery compartment. Be very careful not to get any dirt on the
o-ring or its sealing surfaces.
13. Carefully press the lid onto the battery compartment with your thumb. It is bet-
ter to press down the lid down one side first, this minimizes entrapped air and it
is thus easier to hold down the lid. Make sure that the O-ring is not at any point
protruding out on the edge.
14. Put your other thumb through the locking ring. Press this thumb firmly against
the lid and release the other one. Make sure that the lid is pressed completely
down!
15. Turn the locking ring counterclockwise with your free thumb and fingers until
it snaps into its locked position.
16. The dive computer should now active it's timekeeping mode and show time
18:00 [6:00 PM] and date SA 01,01. Activate the instrument. Check that:
•
All display segments work.
•
The low battery warning is off.
•
The buzzer beeps and backlight works.
•
All the settings are correct. Reset if necessary.
52