Dive Numbering; Flying After Diving - Suunto ZOOP User Manual

If set to Nitrox mode, the following information will
also be shown:
- the oxygen percentage labeled with O
shown on the left side of the center window
- the current oxygen toxicity exposure shown
with an Oxygen Limit Fraction (OLF) bar
graph along the left side of the display.
3.5.2.

Dive Numbering

Several repetitive dives are considered to belong to
the same repetitive dive series when the dive compu-
ter has not counted the no-flying time to zero. Within
each series, the dives are given individual numbers.
The first dive of the series will be numbered as DIVE
1, the second as DIVE 2, the third as DIVE 3, etc.
TABLE 3.3. WARNING SYMBOLS
Symbol
on display
Diver Attention Symbol - Extend Surface Interval
Violated Decompression Ceiling
Do Not Fly Symbol
If you start a new dive with less than 5 minutes of
surface interval time, the dive computer interprets this
as a continuation of the previous dive and the dives
are considered to be the same. The diving display
will return, the dive number will remain unchanged,
and the dive time will begin where it left off. After
5 minutes on the surface, subsequent dives are, by
definition, repetitive. The dive counter displayed in
the Planning Mode will increment to the next higher
number if another dive is made.
3.5.3.

Flying After Diving

The no-flying time is shown in the center window
next to the airplane image. Flying or travelling to
a higher altitude should be avoided at any time the
computer counts down the no-flying time.
% is
2
Indication
m
MAX
SURF
NO
TIME
ºC TIME
Fig. 3.28. Surface interval,
no-flying time. Pressing
TIME button twice will
show no-flying time, indi-
cated by an airplane symbol.
31